You can write the comparator code in the
equation editor. Accept all the zone monitoring temperature outputs from the
building. Compare each to its values then send the most appropriate signal to
the thermostat. John Bisgrove Earth Sensitive Solutions (315)253-3779 From: David Bradley [mailto:bradley@tess-inc.com] Sek, Dear trnsys users, I've simulated a conventional air condition system
with 8 zones representing the floor area. I've split the 8
zones into 2 groups with different areas and attempted
to use 2 thermostats, type 108, to control each group to obtain
2 different sets of results. However, when I link the building to
type 108, I am only able to link one zone to the monitoring temperature. I
would like to find out if it is possible to either seperate the 8 zones
into 2 groups and controlled by 2 thermostats, or combine the total
zones to be controlled by one thermostat. Any advice would be greatly
appreciated Best Regards, Sek Jun-Yang
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@cae.wisc.edu https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
-- *********************************************************************** Thermal Energy System Specialists (TESS), LLC David BRADLEY 22 N. Carroll Street - Partner P: +1.608.274.2577 F: +1.608.278.1475 E-mail: bradley@tess-inc.com Web Pages: http://www.tess-inc.com and http://www.trnsys.com
*********************************************************************** |