[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[TRNSYS-users] Stuck simulation
Dear TRNSYS users,
I am trying to run a rather big simulation (building + system) with
TRNSYS. The maximum number of outputs was exceeded so that I increased
this value in the source code.
When I run a simulation from the hour 0 until 3000 the "TRNEXE-plotter"
stops at the hour 2678.58 with a classical "This program does not respond"
(the percentage of processor used is 50%, this means TRNSYS is still
running). There is no error message and I have to use CTRL+ALT+DEL to stop
the program. I have checked some simulation variables (temperature,
humidity, PID,...) just when the program stops (Hour=2678.58) but
everything looks normal.
When I run the simulation from the hour 2600 until 3000 I have the same
problem but it happens one hour earlier (2677.80).
I have also tried to run from 2600 until 2680 to see if TRNSYS can finish
the simulation (although the plotter is stuck), but it cannot.
Does anyone have an idea about the causes of this problem (convergence in
TRNSYS, Windows XP,...) ?
Thanks
Kind regards,
--
Vincent DOLISY
Ingénieur de recherche
Université de Liège
Département des Sciences et Gestion de l'Environnement
Unité de Surveillance de l'Environnement (Energie)
185, Avenue de Longwy
B-6700 ARLON
Tel : 32-(0)63 230 937
Fax : 32-(0)63 230 800
Mail: Vincent.Dolisy@ulg.ac.be
WEB : http://www.dsge-arlon.ulg.ac.be/energie/