Hi,
I am using a water-to-water heat pump (type 668) to simulate an existing installation. I have the performance sheet and the capacity data from the manufacturer depend on temperature and the flow at the source and the load. I would like to know if it’s possible to specify the mass flow of the source and load on the Type 668. Do you have any other suggestion to make my way around this problem?
Thanks in advance,
Regards
Philippe Forest Graduate student École de Technologie Supérieure Montréal, Canada Attention à tous les Humains. Nous sommes vos photos. Libérez-nous de vos disques durs. |