[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] attic for Type 56

To: trnsys-users@cae.wisc.edu
Subject: [TRNSYS-users] attic for Type 56
From: Marshall L Sweet/sweetml/O/VCU <sweetml@vcu.edu>
Date: Fri, 29 May 2009 15:38:22 -0400
Importance: Normal
In-reply-to:
List-archive: <https://www-old.cae.wisc.edu/pipermail/trnsys-users>
List-help: <mailto:trnsys-users-request@cae.wisc.edu?subject=help>
List-id: "TRNSYS users mailing list at the Solar Energy Lab, UW-Madison" <trnsys-users.cae.wisc.edu>
List-post: <mailto:trnsys-users@cae.wisc.edu>
List-subscribe: <https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users>, <mailto:trnsys-users-request@cae.wisc.edu?subject=subscribe>
List-unsubscribe: <https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users>, <mailto:trnsys-users-request@cae.wisc.edu?subject=unsubscribe>
References:
Sensitivity:

Hello,

I am trying to model a simple one story home with a ventilated attic and a sloped roof (very similar to the example in manual 6). I have made two walls for the exterior roof with different orientations, nslope and sslope. When I run the simulation the zone temperatures for the downstairs seems to work but the temperature for my attic is the same as the outside ambient air temperature. How do I set up the two roof walls for the attic so that they are angled?

Suppose the two angled walls make a 90 degree angle with each other and a 45 degree angle with the ceiling. Would the slopes and azimuths differ since they are angled in opposite directions?

Thanks,

Marshall

Prev by Date: Re: [TRNSYS-users] Experience with Road Energy Systems?
Next by Date: Re: [TRNSYS-users] mass flow rate balance
Previous by thread: Re: [TRNSYS-users] Experience with Road Energy Systems?
Next by thread: Re: [TRNSYS-users] attic for Type 56
Index(es):
- Date
- Thread