Are active layers required to have fluid flowing always at minimum, or only
when non-zero?
I am receiving an error :
Specific fluid mass flow of active layer in surface 26 below minimum value
of 2.87 kg/m^2.h Please increase the minimum mass flow rate or use the
autosegmentation feature of TRNBuild for subdividing the surface.
I have checked the active layer, it won't auto-segment > 1
And the listed min allowed inlet mass flowrate is listed as 3.57 kg/m^2.h
not the 2.87 kg/m^2.h given in the error message.
I multiplied the area of each floor times the min flow rate for the zone
And set it as an alternative flow, but I still get the ame error.
Thanks for any ideas.
John Bisgrove
Earth Sensitive Solutions
7523 County House Road
Auburn, NY 13021
(315)253-3779
-----Original Message-----
From: trnsys-users-request@cae.wisc.edu
[mailto:trnsys-users-request@cae.wisc.edu]
Sent: Tuesday, December 09, 2008 1:03 PM
To: trnsys-users@cae.wisc.edu
Subject: TRNSYS-users Digest, Vol 48, Issue 13
Send TRNSYS-users mailing list submissions to
trnsys-users@cae.wisc.edu
To subscribe or unsubscribe via the World Wide Web, visit
https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users
or, via email, send a message with subject or body 'help' to
trnsys-users-request@cae.wisc.edu
You can reach the person managing the list at
trnsys-users-owner@cae.wisc.edu
When replying, please edit your Subject line so it is more specific
than "Re: Contents of TRNSYS-users digest..."
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.15/1838 - Release Date: 12/8/2008
6:16 PM
No virus found in this outgoing message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.15/1838 - Release Date: 12/8/2008
6:16 PM
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://www-old.cae.wisc.edu/mailman/listinfo/trnsys-users