[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TRNSYS-users] how not to get output list file(*.lst)
Dear David
Thanks for the swift response.
I used "NOLIST",but I could not suppress the list file.
Do I misuse "NOLIST"card?
Below is a part of deck file.
Thanks in advance.
Sato
*******************************************************************************
*** Units
*******************************************************************************
*******************************************************************************
*** Control cards
*******************************************************************************
* START, STOP and STEP
CONSTANTS 3
START=1
STOP=24
STEP=1
* User defined CONSTANTS
SIMULATION START STOP STEP ! Start time End time Time step
TOLERANCES 0.001 0.0000001 ! Integration Convergence
LIMITS 10000 10000 0 ! Max iterations Max warnings Trace limit
DFQ 1 ! TRNSYS numerical integration solver method
WIDTH 80 ! TRNSYS output file width, number of characters
NOLIST ! NOLIST statement
MAP ! MAP statement
SOLVER 0 1 1 ! Solver statement Minimum relaxation factor Maximum relaxation factor
NAN_CHECK 1 ! Nan DEBUG statement
OVERWRITE_CHECK 1 ! Overwrite DEBUG statement
TIME_REPORT 1 ! enable time report statement
EQSOLVER 0 ! EQUATION SOLVER statement
-----Original Message-----
From: David Bradley [mailto:bradley@tess-inc.com]
Sent: Friday, June 20, 2008 6:58 PM
To: 佐藤 昭一郎
Cc: trnsys-users@engr.wisc.edu
Subject: Re: [TRNSYS-users] how not to get output list file(*.lst)
You can suppress the list file by switching the "LIST CARD" field in the Studio's component control cards from "LIST" to "NOLIST." However, before you suppress the list file, I would recommend that you make a run allowing TRNSYS to write the list file, then look at it and make sure that there aren't a lot of warnings being written there during your simulation.
Kind regards,
David
佐藤 昭一郎 wrote:
> Dear all
>
> I use TRNSYS 16.1.
> I have trouble about getting output a big size list file(*.lst) Please tell me how not to get output list file(*.lst).
>
> Thanks in advance
> yours
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
>
>
>
>
--
***********************************************************************
Thermal Energy System Specialists (TESS), LLC
David BRADLEY 2916 Marketplace Drive - Suite 104
Partner Madison, WI 53719
USA
P: +1.608.274.2577
F: +1.608.278.1475
E-mail: bradley@tess-inc.com
Web Pages: http://www.tess-inc.com and http://www.trnsys.com
***********************************************************************