[TRNSYS-users] active layer

["Rahma GUECHCHATI" <rguechchati@gmail.com>]

Hello;

 

I want simulate a building (type 56)  heated by a  direct solar floor used active layer defined in TRNBuild.

I created a wall with an active layer After finishing the wall definition, the wall is marked with an "A" in the overview box of walls.

then I click on Active Layer Specification Bar, i defined all the parameters "inlet temperature=1*tfluid, number of fluid loops=50, inlet mass flow rate=1*flow rate,gain=0" then i pushing the DO-Button but the wall window shows the active layer wall i defined does not indicated by AS. it is always defined by A and when I run my project I get error. I want to know where is the problem.

 

Best  regard

 

rahma

Attachment: MAISONE..bui
Description: Binary data