Dear Jens,
Perhaps it has something to do with your Windows
country settings (in the control panel)? If the decimal indicator (correct
word??) is set to a comma it could give such problems.
Met vriendelijke groeten,
Stefan de Kool
Cauberg-Huygen Raadgevende Ingenieurs B.V.
Bezoekadres: Boterdiep 48, 3077 AW
ROTTERDAM
Postadres: Postbus 9222, 3007 AE
ROTTERDAM
Telefoon: +31 (0)10-2443638
Fax: +31 (0)10-425 44 43
http://www.chri.nl
E-mail: s.dekool@chri.nl
Van: Jens Apel
[mailto:jens_apel@arcor.de]
Verzonden: dinsdag 30 oktober 2007
16:05
Aan: trnsys-users@engr.wisc.edu
Onderwerp: [TRNSYS-users] Plugin
Tess Type 534
Dear all,
I’m, using TRNSYS 16.1 with TESS libs 2.0 V1
with the simulation studio. When I configure the tank type 534 with the plugin
I get the following problems. I have a tank volume of 1.83 cubic metres and a
tank height of 2.69 metres and put it in exactly like that. When I then close
the plugin and open the tank input file *.dat there are the correct values, but
with a comma “,” instead of a dot “.”. So the next time
I open the plugin I have got a tank volume of 1 cubic metre, a height of 83
metres and propylene glycol – water mixture with 69 percent. So the tank
takes the parameters comma separated.
Did anybody come along the same problem and knows
advice? Is it possible that it is because I’m running a german operating
system where the dot “.” is changed to a comma “,”? Can
I write comments into the tank input file? I tried “*” and
“!” but seemingly that didn’t work.
Thanks for any help
Jens Apel
Technical University of Berlin