|
Dear all, I’m, using TRNSYS 16.1 with TESS libs 2.0 V1
with the simulation studio. When I configure the tank type 534 with the plugin
I get the following problems. I have a tank volume of 1.83 cubic metres and a
tank height of 2.69 metres and put it in exactly like that. When I then close
the plugin and open the tank input file *.dat there are the correct values, but
with a comma “,” instead of a dot “.”. So the next time
I open the plugin I have got a tank volume of 1 cubic metre, a height of 83 metres
and propylene glycol – water mixture with 69 percent. So the tank takes
the parameters comma separated. Did anybody come along the same problem and knows
advice? Is it possible that it is because I’m running a german operating
system where the dot “.” is changed to a comma “,”? Can
I write comments into the tank input file? I tried “*” and “!”
but seemingly that didn’t work. Thanks for any help Jens Apel Technical University of Berlin |