Dear all,
I used the TRNSYS to optimize the Ground Source Heat Pump system (GSHP). I build an optimization of GSHP in the base of studying the TRNPOT and GenOpt, It always has a mistake. I looked at the GenoptInputFile.lst. The mistake is as followed. But the system can run when I didn’t optimize. Why GenOpt can not read SAMP_C12.1.DAT(SAMP_C12.1.DAT is the data of heat pump.
*** Fatal Error at time : 0.000000
Generated by Unit : Not applicable or not available
Generated by Type : Not applicable or not available
TRNSYS Message 350 : Unable to open the file associated with an ASSIGNED logical unit number. Please check the ASSIGN statement and make sure that the file exists at the specified location
Reported information : Logical Unit = 48, FileName = HEATPUMPMODEL\BEIJINGWINTER\SAMP_C12.1.DAT
*********************************************************************************************************
The Following UNIT Numbers, TYPE Numbers, and Logical Units Were Used in the Supplied TRNSYS Input File:
4
6
9
30
31
32
33
34
48
Many thanks,