Re: [TRNSYS-users] Problem with my power consumption

[David Bradley <bradley@tess-inc.com>]

Samir,
 Your flow rate is a constant value as well. The power output that
you are plotting is from Pompe EG hbgtso. The input control signal to
that pump is not connected from any other component and its initial value
is set to 1.0 so the pump is on throughout the simulation.
Regards,
 David
 

At 09:00 5/15/2007, Chehal, Samir wrote:

> Dear Trnsys
> users,
>
> I have another problem.
>
> I don?t understand why my power consumption is a constant
> value ( equal to rated power
> defined in parameter) whereas my flow
> rate is not constant.
>
> Best regards <<Wizard25.bui>>
> <<Wizard25.tpf>> 
> =========================================================
>
> NOTICE - This communication may contain confidential and privileged 
> information that is for the sole use of the intended recipient. Any
> viewing,
> copying or distribution of, or reliance on this message by
> unintended
> recipients is strictly prohibited. If you have received this message
> in
> error, please notify us immediately by replying to the message and
> deleting
> it from your computer.
>
> ========================================================= 
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users

****************************************************************************************
Thermal Energy System Specialists (TESS), LLC
David BRADLEY                           2916 Marketplace Drive - Suite 104
Partner                                        Madison, WI 53719
Phone: (608) 274-2577 USA
Fax: (608) 278-1475
E-mail: bradley@tess-inc.com
Web Pages:  http://www.tess-inc.com     and      http://www.trnsys.com

"Providing software solutions for today's energy engineering projects"
****************************************************************************************