[TRNSYS-users] PID controller

["mike matheus" <matheusmike@hotmail.com>]

I am creating a project with a PID controller that mixes two air streams to 
maintain a set hum. ratio, then heats the air mixture in a crossflow heat 
exchanger.  The mixing of the air streams is controlled by the PID and works 
well as long as the inputs into the heat exchanger are constant.  When I add 
a pump onto the hot side of the heat exchanger with varying conditions, the 
simulation will not run.  I get a series of warnings about (TRNSYS Message 
315) connection sequences.  Has anybody else had a similar problem with 
version 16?  Any ideas on how to fix it?

Thank you,

MIke Matheus

_________________________________________________________________
Is your PC infected? Get a FREE online computer virus scan from McAfee® 
Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963