Re: [TRNSYS-users] data reader

["Diego A. Arias" <daarias@wisc.edu>]

Dear Thibaut,

You may try to use Type 9e.  This is a generic data reader that 
recognizes the spaces or tabs between the data columns and reads it 
appropriately. In this version of the component, you do not have to 
specify the format for reading the data.
Best regards,

Diego

Thibaut VITTE wrote:

> Dear Trnsys users,
>
> I want to read data from this file:
>     1    1      1   2.7   0.0041    0  1.00   160
>     1    1      2   2.7 0.00415    0  1.33   173
>     1    1      3   2.5 0.00409    0  1.67   187
>     1    1      4   2.3 0.00408    0  2.00   200
>     1    1      5      2 0.00403    0  2.33   197
>     1    1      6   1.8 0.00397    0  2.67   193
>      ....
> The problem comes with the 5th line, where there is 2 instead of 2.0. 
> when I read it, I get 0.2. The data card I use is:
> (19X,F5.1,....). I can't see the solution, and I can't replace it 
> because there are a lot of that cases in my file.
>
> Thanks in advance!
>
> Thibaut Vitte, phd student, INSA de Lyon
>
> _______________________________________________
> TRNSYS-users mailing list
> TRNSYS-users@engr.wisc.edu
> https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
>  


--

Diego A. Arias
TRNSYS Coordinator
Solar Energy Laboratory
University of Wisconsin - Madison
1500 Engineering Drive
Madison, WI 53706