|
Dear Trnsys users,
I have some problems to "run simulation" in project
made by TRNSYS 15, with TRNSYS 16. It is a building simulation project with type
56.
I have translate the old project from TRNSYS 15 to TRNSYS 16 without loosing the old conections. The project runs very well in TRNSYS 15,
but when I try to run it, in Trnsys Simulation Studio (TRNSYS 16) I get the next messages " Range check error " After clicking the OK BUTTON, I get
An unexepected error was encountered and TRNSYS
will abort.
Open the list file I see warnigs and notices. The
most of the notices
are related with TYPE 501(Ground Temperature Model - Utility Library TESS). Is the only model I use from TESS library (see attached file building.lst) Any hints would be welcome.
best
regards Olympia
Dipl.-Ing. Olympia
Zogou Laboratory of Thermodynamics & Thermal
Engines Department of Mechanical & Industrial
Engineering University of
Thessaly Pedion Areos, 383 34 Volos,
Greece Tel.
(+3024210) 74013, Fax (+3024210) 74096, E-mail: olyz@uth.gr http://www.mie.uth.gr/labs/ltte/info/info.htm |
Attachment:
building.lst
Description: Binary data