[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] electrolyser



Dear all,
We are having some problems in using the type of the electrolyzer. In particular the simulation send us a warning message about the IDmax like this:
********WARNING********

UNIT 3 TIME = 126.000

TOO HIGH ELECTROLYZER CURRENT = 184.61[mA/cm^2]

MAXIMUM CURRENT DENSITY = 184.00[mA/cm^2]

**********************,

We calculate the inlet current of the electrolyzer according to the production of H2 required by the user. We know that in some cases the current may exceed the parameter IDmax but in that case the electrolyzer must work at 100%load and so the input IELYshould be the same (IDMAX).

We have read the code fortrand of the type, but we have not found a condition like this :

IF Iely > Imax
  THEN Iely = Imax
.......
So, it is possible to introduce this in the IISiBat Project with a particular type or we should modificate the fortrand code of the electrolyzer?

Any helps?
Thank you!

Sara and Manu