[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TRNSYS-users] parametric run
Isabelle,
I am trying a parametric run. I am wondering if I'm doing things right.
I create a trnsys file in IIsiBat. I open the so created .dck file in
TRNSHELL. I replace some equations by a CONSTANT statement and create my
parametric table.
But if I make any modification in IIsiBat, when I come back into
TRNSHELL, I have to do these two operations again. Is that right ? (I
hope mu explanation is not too confused...)
Unfortunately you are correct. There is no way back to IISiBat once you
started editing a deck file in TRNSHELL (that is, there is a way back
but you loose most changes).
Please note, however, that you can have CONSTANTS statements in IISiBat.
You just have to enter them by hand in the "Simulation Cards" field in
"Control Cards". You can use the constants in the project by typing
their name in an initial value or parameter field (after setting the
"type" to "string"). That way you can setup your simulation completely
in IISiBat and just use TRNSHELL to run the parametric study.
Kind regards,
Michaël Kummert
--
_________________________________________________________
Michaël Kummert
Solar Energy Laboratory - University of Wisconsin-Madison
1303 Engr Res Bldg, 1500 Engineering Drive
Madison, WI 53706
Tel: +1 (608) 263-1589
Fax: +1 (608) 262-8464
E-mail: kummert@engr.wisc.edu
SEL Web Site: http://sel.me.wisc.edu
TRNSYS Web Site: http://sel.me.wisc.edu/trnsys