Welcome to the TRNSYS Users Forum.

The forum is a place where people can interact and have discussions about different topics involving the use of the TRNSYS software package. Here you can post topics for discussion or questions on using TRNSYS and get advice from other users or TRNSYS experts. This forum is not intended for detailed technical support. Users should contact their distributor’s hotline for such assistance.

Some tips for success on using the forum:

  • Follow the Forum Rules posted in Forum Administration.
  • There are categories for different types of topics and questions. Post your topic or question into the proper category.
  • Before posting a topic or question search the existing topics  (and the TRNSYS Users listserv archive or Post archive) to see if a similar topic or question has already been answered.
  • Use a descriptive topic name. Don’t use attention getting subjects, they don’t get attention and only annoy people.
  • State the version of TRNSYS and which add-ons your are using.
  • Include enough specific details for your topic of question to be answered. Just posting “Why am I getting an error?” without describing the specific error and what you are trying to do when you get the error will not receive a response that fixes your issue.
  • Remember when people help you, they are doing you a favor. Be patient, help people out by posting good descriptions of what you need help with, and be polite even if a response does not solve your issue.
  • Moderators may edit your post for clarity or move your topic to a more appropriate category.

Notifications
Clear all

Load Profile component

1 Posts
2 Users
0 Reactions
192 Views
0
Topic starter

Is there a component in TRNSYS 18 that describes the electrical load profile so I can connect to set of compressors? also if i want  to control the whole system so that half of the system works and after the storage tanks is filled so the other part of the system works, what is the component?

1 Answer
0

If your load profile is a repeating pattern (like a daily schedule), you can use the Type 14 forcing function to define your load profile. If your load profile comes from measured data, you can use the Type 9 data reader to read in your load profile. You can also see this post for a related question about setting up repeating profiles for weekdays vs weekends and different seasons, if applicable. 

 

 

There are a number of ways to control your system. For example, you could use the basic aquastat model in the standard Controllers library to produce an on/off signal based on some indicator of the tank's fill (mass, pressure, % of full, or whatever indicator you have available or prefer). The aquastat models (in fact most of the controller models) are written with temperature control in mind, but there's no reason the same control principles can't be applied to mass, pressure, or other variables. (Well, there's one reason ... the Simulation Studio won't allow outputs and inputs in different unit systems to connect. You can get around that by a) for a quick fix, passing the mass/pressure/etc. you want to monitor through the equation block, which will disassociate the value from its units, or b) for a more permanent fix, create a new proforma for the controller with the correct units for the monitored variable). You could then connect the on/off control signal from the controller directly to your system components, and/or to a diverting valve that directs flow to one part of the system when the signal is 1, and another part when the signal is 0.

Share: