Welcome to the TRNSYS Users Forum.
The forum is a place where people can interact and have discussions about different topics involving the use of the TRNSYS software package. Here you can post topics for discussion or questions on using TRNSYS and get advice from other users or TRNSYS experts. This forum is not intended for detailed technical support. Users should contact their distributor’s hotline for such assistance.
Some tips for success on using the forum:
- Follow the Forum Rules posted in Forum Administration.
- There are categories for different types of topics and questions. Post your topic or question into the proper category.
- Before posting a topic or question search the existing topics (and the TRNSYS Users listserv archive or Post archive) to see if a similar topic or question has already been answered.
- Use a descriptive topic name. Don’t use attention getting subjects, they don’t get attention and only annoy people.
- State the version of TRNSYS and which add-ons your are using.
- Include enough specific details for your topic of question to be answered. Just posting “Why am I getting an error?” without describing the specific error and what you are trying to do when you get the error will not receive a response that fixes your issue.
- Remember when people help you, they are doing you a favor. Be patient, help people out by posting good descriptions of what you need help with, and be polite even if a response does not solve your issue.
- Moderators may edit your post for clarity or move your topic to a more appropriate category.
Dear trnsys users,
I have a problem and I need your help..
I simulate a small project but whet i run it it appears an error with message 48:
TRNSYS Message 48 : The TRNSYS processor has reported that an unrecognized control card was found while trying to read the input file. This error can be caused by underspecifying a required number of items in the input file. For example, specifiying only 9 parameters after a "PARAMETERS 10" card has been read can cause this error. The line that caused this error is listed in the reported information below.
Reported information : -1
Can you tell me what is going wrong and I cannot take results? I enclose the project to test it.
Thank you in advance,
This error likely stems from an incorrect definition in the control/simulation cards found in Settings -> Advanced Settings. Similar errors can also occur when a parameter is added to source code but not updated in the corresponding proforma or vice versa. If the error persists, please contact your distributor with your project (.tpf) file and any files needed to run it.
cheers,
John
