Re: [TRNSYS-users] TRNSYS3D question

[David BRADLEY <d.bradley@tess-inc.com>]

You can click "yes." SketchUp entities are entirely irrelevant to the Trnsys3d entities and vice versa. This message sometimes comes up if you have opened a SketchUp model and then traced over its objects to create Trnsys3d objects. However, it also sometimes comes up if you have accidentally drawn something when a Trnsys3d zone was not selected. When a Trnsys3d zone is not selected then shapes you draw aren't tied to a zone and when you close, then reopen the file they will disappear.

kind regards

 David

On 2/12/2023 1:47 AM, H via TRNSYS-users wrote:

Hello, everyone,

  There is an question when I open my sketchup model of TRNSYS3D, as shown in following picture. Why did it occur and which one should I choose（Yes or No or cancel)?

                                                                                          Best regards,

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy System Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com