Dear all,
My model is able to run as normal(single run is no problem), but when I click the Parametric Study the whole trnsys freezes and then the system does not respond. I tried some solutions as below:
- I run the simple old model, Parametric Study is available. Only some recent models are disable to run Parametric (But these model were able to run Parametric before I met this issue).
- I reinstall the trnsys, still disabled.
- I update my laptop and reboot many times, still disabled.
I am writing to ask if anyone know how to solve this issue. Thanks in advance.
Best regards,
Xinman
www.polyu.edu.hk
 |
Disclaimer:
This message (including any attachments) contains confidential information intended for a specific individual and purpose. If you are not the intended recipient, you should
delete this message and notify the sender and The Hong Kong Polytechnic University (the University) immediately. Any disclosure, copying, or distribution of this message, or the taking of any action based on it, is strictly prohibited and may be unlawful.
The University specifically denies any responsibility for the accuracy or quality of information obtained through University E-mail Facilities. Any views and opinions expressed are only
those of the author(s) and do not necessarily represent those of the University and the University accepts no liability whatsoever for any losses or damages incurred or caused to any party as a result of the use of such information.