Aly,
I don't think that there is a right or a wrong way to go about this so long as you are consistent. I typically use the middle of the wall in my measurements.
kind regards,
David
On 12/11/2022 11:54 PM, Aly Osman via
TRNSYS-users wrote:
Dear All,
I asked earlier about importing dwg to sketchup for trnsys3d and I received a reply that I should trace over the lines in my zones.My question is since my walls are drawn in full width, where should I start tracing (from the outer side or the inner side or from the middle of the wall?
--
Kind regards,
Mr. Aly OsmanMSc. Mechanical Engineering
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@lists.onebuilding.org http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
-- *************************** David BRADLEY Principal Thermal Energy System Specialists, LLC 3 North Pinckney Street - suite 202 Madison, WI 53703 USA P:+1.608.274.2577 d.bradley@tess-inc.com http://www.tess-inc.com http://www.trnsys.com