[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] Fwd: Invalid floating point operation



Dear fellow TRNSYS users,

I would like to raise the subject of "Invalid floating point operation", since going through the mailing list for earlier mentions on the matter did not really help.  
I've noticed that this error does not necessarily seem to be a component or input-dependent issue. 
For instance, when I run a single simulation with type56 and this error occurs, I rerun it without any differentiation and the simulation is completed successfully. Similarly, when I run a parametric simulation of many cases via TRNEDIT and this error pops up in a specific case, I rerun the single simulation successfully without changing anything.
I 've also tried several PCs, in case there is anyhow related to the operating system without concluding to any helpful outcome.

Any ideas/ comments/ suggestions on that?         

Best regards, 

Manos Katsigiannis
Energy and Sustainability Engineer, M.Sc.
Researcher | NTUA | School of Mechanical Εngineering
S:  ma_kats