Dear all,
I am trying to use TRNOPT for parametric/optimisation runs, but when I run the simulation (after setting all the settings up as shown in the documentation relative to TRNOPT) I get an error message and the simulation stops before even starting. The error is shown in the attached picture 1.
It reports that I need to specify at least one output for the surface number (-1) while this number associated with this supposed surface does not exist at all in my TRNBuild project.
Also the zone number is not specified in the error message (while there are 2 thermal zones in my project).
If anyone encountered this issue I would grateful to receive help
Best regards,
Amin
