Re: [TRNSYS-users] Division by Zero

[Brahim Benhamou <bbenhamou@uca.ac.ma>]

Said

I don't know if this will help. According to my students feedback, it seems  the SketchUp drawing and IDF import should be done in one step. Reopening the SketchUp results in adding zones! I known that this doesn't make sense, but it is a fact that many students faced.

Good luck

Brahim

----
Brahim Benhamou, PhD
Professor

- Laboratory of Processes for Sustainable Energy & Environment - ProcEDE
- EnR2E Laboratory at CNEREE
Cadi Ayyad University Marrakech

https://www.researchgate.net/profile/Brahim_Benhamou

Faculty Advisor of InterHouse team, the winner of Solar Decathlon Africa SDA2019
President of InterHouse Association for Sustainable Construction
https://www.solardecathlonafrica.com/ 
https://interhouse.club/team-2/

Post mail:
Physics department
Faculty of Sciences Semlalia
PO Box: 2390 Marrakech 40001
bbenhamou@uca.ac.ma
Mobile : +212 673 779 122
Skype : Brahim_Benhamou

   

On Mon, Jun 14, 2021, 14:05 Said LAMGHARI via TRNSYS-users <trnsys-users@lists.onebuilding.org> wrote:

Dear all, 

I tried to simulate a building of 7 thermal zones but it does not work; It gives errors showing in enclosed images and when I check SketchUp , I found it adds thermal zones that I do not even create. on the other hand for the three zones worked very well. Does anyone have an idea about the problem? 

Kind regards,  

Said LAMGHARI 

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org