| Erik,
Can you post the parameters of your feedback controllers so we can see if anything stands out?
But also let us know what you’re trying to do. I’ve been doing solar heating in TRNSYS for a long time and have never run into a situation where I had to use two feedback controllers in a project - rarely even just one. And I’ve literally done thousands of solar project in TRNSYS.
Jeff - TESS On May 7, 2020, at 9:59 AM, Erik Eriksson via TRNSYS-users <trnsys-users@lists.onebuilding.org> wrote:
Hi again!
Im using two feedback controllers but in different circuits in a solar heating system. When Im plotting the control signals out from them one can give all values between 0.05 to 1 while the other one only gives signals of 0.15, 0.30, 0.45,
0.60, 0.75 and 1. I have compared the settings and those are the same. Any thoughts about this?
Regards Erik
_______________________________________________TRNSYS-users mailing listTRNSYS-users@lists.onebuilding.orghttp://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
|