Hello TRNSYS users,
I would like to divide a glazing surface into several ones, as shown in the figure below. My first guess (using sketch up) was to draw the entire surface and then divide it into equal glazing surfaces by drawing horizontal
lines (in this case, all the glazing surface are linked)
But, it TRNSYS, no glazing surface appear. It seems that the glazings appear only if I separate them to one another by an opaque surface. So, instead of just drawling a line, I let a very small space (0,1 mm) between
the glazings and now they all appear in TRNSYS.
My question is : would you have done the same or is there a better method ?
Wirich FREPPEL
Development engineer
COSMOS -
Buildings Energy Performance & Daylighting Group
Cell: +33 637 053 174
Saint-Gobain Research Compiègne
Attention, si vous recevez ce mail un jour chômé (ou une demi-journée) dans le cadre de l’activité partielle, merci d’attendre le prochain jour travaillé pour y répondre.
If you are in a furlough mode when receiving this email, please don’t answer it right away and reply
at your next possible working day. Thank you