Hello everyone,
I am trying to apply a thermal curtain to reduce the heating load
I know its thermal characteristics, but how do I set it up?
The "wall characteristics" must change with schedule.....
And also, during the day, this should be considered as multi air nodes zone with victual surface.. (same radiation zone)
But I can't change the characteristic of this wall in the middle of calculation.
The window ratio was 99.9% and was set to "no glazing-open" of the German library. and I tried this by adjusting the window frame ratio to thermal curtain c-value with "input".
Is this reasonable?
I think it is unreasonable to increase the window (no glazing-open) temperature due to solar radiation.
While the temperature of the floor is not high, the surface of the window(no glazing-open) is hot.
How should I solve this? Recommend a reasonable way to apply this.
Thank you.