Salma,
There are (as usual) a number of different ways of having all
the results from a parametric run put into the same output file.
One way is to use a Type25 printer as an output device in your
simulation and to set it to "append" mode instead of "overwrite
mode." The mode is controlled by a parameter. The other thing
you'll need to do is to make sure that the name of the output file
is NOT the same as the name of your input file, otherwise there
will be one output file produced per table run. Note that a number
of the standard printer output components in TRNSYS allow the
switch between append and overwrite mode.
kind regards,
David
On 12/08/2019 07:33, SALMA LAHMAR via
TRNSYS-users wrote:
I have to run a lot of simulations to calculate the building energy consumption depending on the value of different parameters.I tried to use trnedit to make a table but I don't know how to have a result of all simulation in one output file like : \Examples\Parametric Runs\SDHW-ParametricRuns in trnsys.thanks in advanceᐧ
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@lists.onebuilding.org http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
-- *************************** David BRADLEY Principal Thermal Energy Systems Specialists, LLC 3 North Pinckney Street - suite 202 Madison, WI 53703 USA P:+1.608.274.2577 F:+1.608.278.1475 d.bradley@tess-inc.com http://www.tess-inc.com http://www.trnsys.com