[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] COP curve inconsistency WW-HP



Hello everyone,

I got the results from a simulation and I think I am getting inconsistent results when comparing the heat pump COP and comparing it normalized performance data sample included with the component, which is the one I am currently using (type 927).

The system is basically two identical heat pumps (50RT) being controlled by a multi-stage differential controller. (which is also controlling the flow rate for both source side and load side pumps). So for the load side (connected to a vertical heat exchanger) there is only really small changes in temperature and the flow-rate goes from 0 to 0.5 to 1 following the number of H.Ps on. 
Load side flow-rate also goes from 0 to 0.5 to 1 but there are bigger temperature changes according to the demand.

But, according to the performance data, during heating mode, the load side flow-rate should no change normalized capacity and if the load side temperature increases, normalized capacity should decrease. Which was not what happened with my results.

Can someone with a better understanding about H.Ps take a quick look and see if this graph is reasonable compared to the performance curve?

Thanks in advance

  

Attachment: COP.jpg
Description: COP.jpg