Dear Trnsys users,
I am facing following two errors.
Error 1. Trnsys Message 203: A convergence problem was encountered. Modification of the TOLERANCE control card may cure the problem.
To tackle this error i reduced time step but then simulation studio take almost half an hour to perform one simulation. What else i can try to fix this error?
Error 2. Trnsys Message 450: 
My question is, how i can increase the number of these warning at my computer. Message says use LIMITS command. But i am unable to understand that how and where i have to use this command. Please shed some light on this as well.
Thank you.
Best Regards,
Sajid
The University of Edinburgh is a charitable body, registered in Scotland, with registration number SC005336.