Karol,
I seem to recall having this happen to me once too and that it was solved by closing down the Studio and reopening it. As far as I know there is no setting that you can switch to default to direct links or orthogonal links.
David
On 04/10/2019 03:13, Karol BANDURSKI via TRNSYS-users wrote:
Dear All,
Just simple issue. I would like to have perpendicular bends in links between
types in my Simulation Studio model, but last time every link which I have
created is direct, straight between types.
How can I change it?
Regards,
Karol
--------------------------------------------------------------------
Karol BANDURSKI M. Sc.
Faculty of Civil and Environemntal Engeneering
Division of Heating, Air Conditioning and Air Protection
Poznan University of Technology
www.put.poznan.pl/~karol. bandurski
https://www.researchgate.net/profile/Karol_Bandurski
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com