[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] (no subject)

Hello all

I created a trnsys program for seasonal thermal energy storage using flat plate collector. The system is bit complicated, but I got good simulation results at the end according to the conditions provided by our collaborator.

Now I came to know that the values of a0, a1 and a2 of flat plate collector are different from the one I was using. When I input the corrected values, the system run but got stuck while running.
I tried to change the flow rates then. But the results happens to be poor. I don't know which parameter I should adjust in order to get better results.

Helpful suggestions on this would be appreciated.

Thanks 
Jibi 
--

-----------------------------------------------------------------------------
Jibi Jais
Doctoral Researcher
Renewable Energy Laboratory, Room 203-2
Department of Mechanical Engineering
Graduate School, College of Creative Engineering
Kookmin University
77 Jeongneung-ro, Seongbuk-gu, Seoul, 02707, Korea
Tel : +82-10-4496-4221, +82-2-910-5031 (O)
-----------------------------------------------------------------------------