Make sure that the Type109 appears before Type56 in the
component order. While you are there, make sure that the Type68
appears after the Type109 and before Type56. Component order can
be modified in the control cards tool (where you go to set the
simulation start and stop times)
Dear David,
thank you for the advice. Unfortunatly, when I link the IA
directly from type109, I have multiple warnings with this
message: "Beam radiation greater than 0 occured for an incident
angle of 97.52 greater than 90° for orientation 6. Beam
radiation has been set to 0.!"; and the simulation stops when
the threshold of 30 warnings is reached.
Orientation 6 is 90°/315° (south east wall). For the roof's IA,
there are no problems if only them are linked from 109 to 56.
When I link one or many walls, this issue happens. Certainly
because of a mistake of mine, but I don't see what it could be.
Thanks a lot for your help.
Kind regards,
Olivier
Le 2019-03-08 16:43, David BRADLEY a écrit :
Olivier,
Almost! the AI-orientation input is asking for the angle of
incidence of beam radiation on the surface. That should come
directly from the weather component to Type56. You are correct
about the other two
kind regards,
David
On 03/08/2019 08:38, Le Talave via
TRNSYS-users wrote:
Dear Trnsys community,
To be sure not to make a mistake about how to plug type68
with type56. Is it true to plug (Type68 ------>Type56):
Solar Altitude Angle--------->AI-ORIENTATION- ?
Shaded total rad. for surface--------->IT-ORIENTATION- ?
Shaded beam rad. for surface---------->IB-ORIENTATION- ?
Many thanks for your advices
Best regards,
Olivier
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org
--
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI 53703 USA
P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com
http://www.tess-inc.com
http://www.trnsys.com