[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] Fw: Optimization using the TrnOpt, externally using the GenOpt

Yuekuan

 The "C:\Program" that is referenced in the message is important. I think it means that you have GenOpt installed in the c:\Program Files\ directory. I would recommend that you reinstall GenOpt in a different directory. I would recommend installing it in C:\GenOpt\. Please note that you will have to adjust the settings in TRNOpt according to the new directory in which you install GenOpt.

regards,

 David


On 01/14/2019 23:49, 鹰隼 via TRNSYS-users wrote:


---Original---
From: "鹰隼"<820173803@qq.com>
Date: Mon, Jan 14, 2019 13:39 PM
Subject: Optimization using the TrnOpt, externally using the GenOpt

Dear all,

  I am the TRNSYS 18 user. I try to optimize the system design paramaters  using the TrnOpt, externally using the GenOpt. One question is  shown below:

when I open the  WinGenOpt to open the GenOpt project initialization file "GenOpt.ini", one error appers:
 Cannot run program "C:\Program" (in directory "C:\TRNSYS18\genopt-type56\GenOpt-Type56\tmp-genopt-run-1"): CreateProcess error=2, Can't find the specified files.

  I have checked the file path, it is actually exists.
 
  Any suggestions are appraciate.

Thanks for the attention!

Best wishes!

Yuekuan

The Hong Kong Polytechnic Univesity

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
3 North Pinckney Street - suite 202
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com