Dear Experts my model are rooms with thermally activated slabs (ceilling). In each room there are a few loops od pipe in slab with the same specific mass flow rate and the same inflow water temperature. My aim is to get value of water outflow temperature from the room (so after all loops come togather) as close as possible to reality. There are two ways, according to may knowledge: - model each loop as separate partition in the ceiling, so there will be a few ceilings - model ceiling of room as one partition but with a few loops. Is both approach right or not? What are de differences in calculations? I enclose pdf with graphical explanation. Kind regards, -------------------------------------------------------------------- Karol BANDURSKI M. Sc. Faculty of Civil and Environemntal Engeneering Division of Heating, Air Conditioning and Air Protection Poznan University of Technology https://www.researchgate.net/profile/Karol_Bandurski www.put.poznan.pl/~karol.bandurski |
Attachment:
TABS-loops.pdf
Description: Adobe PDF document