Re: [TRNSYS-users] PVT solar collector with to heat gain

[Amirreza Heidari <amirrezaheidarysbu@gmail.com>]

Thank you very much for your feedback

Sender notified by Mailtrack

--------------------------------------------------------------------------------------------------------------------------------------------------

Amirreza Heidari

Department of Energy Engineering

Sharif University of Technology

Tehran-Iran

E-mail address:

heidari@energy.sharif.edu

amirrezaheidarysbu@gmail.com

P Save a tree... Please don't print this E-mail unless you really need to.                                                                                                                              

On Wed, May 16, 2018 at 8:36 AM, Jibi Jais (지비 제이즈) via TRNSYS-users <trnsys-users@lists.onebuilding.org> wrote:

Hai

I think you have a very large flow rate such that there is a negligible temperature rise across the collector.

Try reduce the flow rate and see again.

I also faced a similar problem before.

Regards

Jibi Jais

On Sun, May 13, 2018 at 4:36 AM, Amirreza Heidary via TRNSYS-users <trnsys-users@lists.onebuilding.org> wrote:

Dear All

I have used the PVT solar collector (type 560) for Sydney climate. I do not see any temperature increase in the collector fluid outlet temperature compared to the inlet temperature! I have checked the radiation inputs. Do you have any suggestions?

Thank you

                                                                                                               

Sender notified by Mailtrack

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org