[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] type 155 and GenOpt



Hi TRNSYS users,

 

I’m trying to run an optimization with TrnOpt with a link with matlab (type 155). The single simulation works, but when I run the optimization I have always the same error: “The M-File did not properly set 'mFileErrorCode' to 0 when it was called. This may indicate that an error occurred in Matlab while running the M-File. 'mFileErrorCode' was left to 1 by the M-File. You can set ignoreEngineClose to 1 and run the 'lasterr' command in Matlab to help diagnose the  problem. The error occurred at info(7) =            0 , info(13) =            0”.

I think it’s a problem  with matlab file access because , despite the .m file being inserted into the GenOpt input file, the GenOpt seems unable to start it, in fact GenOpt starts matlab but then fails to open the file.

 

Someone of you has already dealt with this issue?

 

Kind regards,

 

Elisa Ghirardi

University of Bergamo, Italy.