[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TRNSYS-users] TRNSYS17, TABS, Boundary conditions



I’ve prepared a simulation of a room with TABS (in the ceiling). I have a problem with temperatures that I get in this ceiling. I wonder if it is due to the boundary conditions settings.

Please take a look at the graphical representation of the situation below:

 

1.      1. Do I understand correctly that “heat transfer coefficient” (Manual TRNSYS17, Volume 5 page 109) is supposed to be set to “less than 0,001kJ/h/m2” regardless of conditions being adiabatic or not?

2.      2. As far as remaining partitions are concerned, should I set “heat transfer coefficient” to “less than 0,001kJ/h/m2”?

3.      3. My room has surface area of 48m2 and volume of 129m3. TABS settings: m_water=601.2kg/h, T_Water=18°C.  TOFL-TIFL =0.7K. What else can cause water temperature difference to be so low?

 

 

Katarzyna Pałaszyńska M.Sc.

Faculty of Civil and Environemntal Engineering

Division of Heating, Air Conditioning and Air Protection

Poznan University of Technology


e-mail: katarzyna.palaszynska@put.poznan.pl

 

 

Attachment: TRNSYS17, TABS, Boundary conditions.docx
Description: application/vnd.openxmlformats-officedocument.wordprocessingml.document