|
An access violation is a very generic error that can be caused by
many different problems. You may get a little more information about the cause of the
error if you go into the component control cards in Simulation
Studio and turn on "debug mode." This will cause your simulation
to run a bit more slowly but will perform some additional checks
that may lead you to a solution. If that does not work then there should be a CVF66 compiler workspace already set up in the ..\Trnsys16\Compilers\ directory that will allow you to recompile the TRNDll itself. I would recommend that you add your component to the TRNDll project then run your simulation from the compiler (instead of from the Studio). This will allow you to step one line at a time through the code in your component and see where the access violation is taking place. There are some instructions on how to do this located in the 08-ProgrammersGuide manual. Lastly, please be aware that Trnsys16 was replaced by v17 in 2009
and by v18 earlier this year. Official support for older versions
continues for a year after the release of a new version. After
that time the distributors try to provide help on earlier versions
when they are able and have some spare time to do so. kind regards, David
On 10/30/2017 03:10, 廖刚 via
TRNSYS-users wrote:
Dear TRNSYS user, I'm trying to create a new component for a solar cooling system.I have installed the CVF6.6 compiler and TRNSYS16. my component model code was compiled without error and the type201.dll was successfully generated,but when I trying to run it in the trnsys studio,I got an error "Access violation at address 08E63E0F in module'Type201.dll'.Read of address 00000002 ". Any help or hints greatly appreciated. Regards. LiaoGang -- *************************** David BRADLEY Principal Thermal Energy Systems Specialists, LLC 22 North Carroll Street - suite 370 Madison, WI 53703 USA P:+1.608.274.2577 F:+1.608.278.1475 d.bradley@tess-inc.com http://www.tess-inc.com http://www.trnsys.com |