Xavier,
Make sure you have all the input files located in the correct place.
For example, the errors you show will occur if the VEF file is not located as specified for Type98.
And this one if the PRJ file is not found.
Calling syntax is as specified in TRNSYS18 Manual.
C:\Program Files\TRNSYS18\Exe\TRNExe.exe C:\MyPRJs\cottage-dcv-32.dck
/h
- Stuart
From: TRNSYS-users [mailto:trnsys-users-bounces@lists.onebuilding.org]
On Behalf Of FAURE Xavier 245257 via TRNSYS-users
Sent: Tuesday, August 29, 2017 12:20 PM
To: TRNSYS users mailing list at OneBuilding.org <trnsys-users@lists.onebuilding.org>
Subject: Re: [TRNSYS-users] TRNEdit pb
Does someone know how to launch batch simulation for a TRNSys-CONTAM project (see message below) ?
I’ve also tried using matlab to change the .dck file but I’m stuck on some new line or carriage return character (\r or \n).
But I cannot fix the problem….
Aside from the TRENEdit pb if someone is able to write the dck file with matlab. I’d would be grateful to have the solution…
Thanks by advance for any help on this.
Xavier
De : FAURE Xavier 245257
Envoyé : jeudi 24 août 2017 13:33
À : TRNSYS users mailing list at OneBuilding.org <trnsys-users@lists.onebuilding.org>
Objet : [TRNSYS-users] TRNEdit pb
Dear all,
I’m trying to launch some parametric simulation using TRNEdit but I hav the following problem.
The first call leads to the following message :
All the *.dck file are created and I can launch them one by one using the TRNSys menu in TRNEdit interface and everything is OK.
But I wanted to launch a lot in batch mode….
the simulations are contam coupled.
Thanks by advance for any help.