thanks for your attention, its very simple equation as it's shown in the attached image
Erfan,can you copy the equations in that equation writer?So we can have a look at it!LeenOn 6 November 2016 at 08:57, Erfan m via TRNSYS-users <trnsys-users@lists.onebuilding.org > wrote:______________________________hi to all transys users,I'm modeling a solar cooling system in the studio, i have cooling loads of the building that is estimated using Design builder software. i put the hourly cooling load in a exel, .xls file to import in type9 component of trnsys and use an equation to gain the temperature data in connect it to a fan-coil unit. problem is after running the model, there an error that says equations or constants must not begin with END,INC, EQU, CON. but there is not any of these names in my project equation component.please help me how to get rid of it.Erfan Malekian,
M.Eng. in Energy Conversion,
Mechanical Engineering Department,
Azad university of Semnan, Semnan, Iran*** Fatal Error at time : 0.000000Generated by Unit : Not applicable or not availableGenerated by Type : Not applicable or not availableTRNSYS Message 11 : The TRNSYS processor has reported an illegal variable name in an EQUATIONS or CONSTANTS card. Equations or constants must not begin with END, INC, EQU or CON as these are protected codes required when reading the TRNSYS input file. The offending variable name is listed below.Reported information : INCIDENT_________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebu ilding.org