Hi,
I would suggest to check at the "externa files" tab of the proforma that the path is ok and the file has not 0 size. If that's ok, at parameters tab, check that those indicating the number of points at the file are set correctly, regards
Angel
Hello TRNSYS users,
I am working on a model with flat plate collectors, thermal storage, external load files, absorption chiller, pumps, controllers, etc. It runs fine.
However, when I change the collector type to linear parabolic concentrator (Type 536) with sample file for Bi-Axial IAMs, I am getting this error : “The utility subroutine DATA cannot read the specified input data file. Make sure that the file is ASSIGNed correctly and that the file has the correct format. Reported information : ASSIGNED LOGICAL UNIT 10”
Any ideas/suggestions?
Thank you.
Regards,
Ratnalee Patil, AAIA
B.Arch., M.A.Sc. Engineering
Energy Specialist
Innovative Design
850 West Morgan St. Raleigh, NC 27603
Ph: (919) 832-6303 Fax: (919) 832-3339
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org