Hamid -
If you check the *.lst file that is created during your simulation it should tell you more about which line has the illegal character.
Regards,
Tim
---
Timothy P. McDowell Executive Vice President Thermal Energy System Specialists, LLC 22 N Carroll St, Suite 370 Madison, WI 53703 608-274-2577
On 2015-10-28 11:10, Heidar Esfehani, Hamidreza wrote:
Hello there,
I’m developing a model in Trnsys, during running my simulation suddenly it gave me a stupid error which I can‘t understand and fix it!
Here is the error tex:
TRNSYS Message 12 : An illegal character was found as the first non blank character in the line referenced below. Lines in the TRNSYS input file may begin with a comment character, a letter, or a number
Reported information : =
I would really appriciate your help in this regards!
Best,
Hamid
Sent from Mail for Windows 10
_______________________________________________ TRNSYS-users mailing list TRNSYS-users@lists.onebuilding.org http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org