Hi TRNSYS-Experts,
I tried to connect two airnodes within a zone in order to have the airflow between the airnodes calculated (splitting a room into 2 airnodes) and came across an Error saying that there aren’t any adjacent wall or coupling. . The “virtual surface” for both zones was created as usual in Trnsys3d and the airnodes were connected into a mutual zone in TRNbuild.
*Refer to image 1.
So I activated the “Upper” coupling with 0 kg/h massflow of both airnodes to each other and came across another error saying that the airlink network isn’t properly connected.
*refer to image 2
Has anybody encountered the same problem? Or did I miss any step in order to simulate an opening in trnflow? I already dig in the mailing list archive and found nothing, it would be nice if somebody can help.
Thanks in advance.
Best regards,
--------------------------------------------------------------------------------
Yose Wandy B.Sc.
Wissenschaftlicher Mitarbeiter
Ostfalia Hochschule für angewandte Wissenschaften
Hochschule Braunschweig/Wolfenbüttel
Fakultät Versorgungstechnik
Institut für energieoptimierte Systeme (EOS)
Prof. Dr.-Ing. Lars Kühl
Salzdahlumer Straße 46-48
D - 38302 Wolfenbüttel
Tel. 0049 - 5331 / 939 – 40 550
Fax 0049 - 5331 / 939 – 40 552
