[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] PID control parameters



A typical HVAC energy model runs with time steps of a few minutes, whereas real PID controllers usually operate on a timescale of seconds. So you may get better performance out of the iterative controller to emulate the behavior of a real PID controller. Or better yet, use a cooling tower type that is able to solve for fan speed as a function of desired outlet temperature instead of one that strictly takes fan speed as an input.

-Ben Heymer

On Wed, Jul 15, 2015 at 3:32 PM, Suhrid A Deshmukh <suhrid@mit.edu> wrote:
Hello,

I am trying to control the temperature of the water leaving the cooling tower to 18C. I am simulating an years worth of data and the simulation timestep in 10 min. I am trying to use the PID controller to do this. i am setting the setpoint variable in the PID controller to 18C and the controlled variable as the temperature of the water exiting the cooling tower. I was wondering what kind of Gain constant and integral time (derivative time can be zero) should I use to get the optimal performance.


Regards,
Suhrid

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/trnsys-users-onebuilding.org