I am getting a large number of convergence warnings. As I understand, this means that the outputs of certain components are not stabilizing to specific values at individual time steps. How can I figure out which components are not converging? It reads Type "0" and Unit "0" next to each warning message in the log. Each warning ends with "Reported information: UNITS: 12 13 14 17", but I can't figure out what this means (what is Unit number?).
I have tried using the TRACE feature, but without knowing where to start looking within the list file, it is hard to figure out what isn't converging. Thanks.
--
Brad Painting
Master of Science Candidate, Renewable Energy Engineering
Department of Technology & Environmental Design
Appalachian State University
Boone, NC 28608