|
Hi, In the online Plotter the label names aren’t allowed to have blancs : * Model "T sol" (Type 65) *
UNIT 23 TYPE 65 T sol *$UNIT_NAME T sol *$MODEL .\Output\Online Plotter\Online Plotter Without File\Type65d.tmf *$POSITION 1159 639 *$LAYER Main #
PARAMETERS 12 6 ! 1 Nb. of left-axis variables 0 ! 2 Nb. of right-axis variables 0 ! 3 Left axis minimum 25 ! 4 Left axis maximum 0 ! 5 Right axis minimum 10000 ! 6 Right axis maximum 1 ! 7 Number of plots per simulation 12 ! 8 X-axis gridpoints 0 ! 9 Shut off Online w/o removing -1 ! 10 Logical unit for output file 0 ! 11 Output file units 0 ! 12 Output file delimiter INPUTS 6 21,1 ! Temp_sol 1.03m:Soil Temperature at Node ->Left axis variable-1 19,1 ! Temp_sol 1.45m:Soil Temperature at Node ->Left axis variable-2 22,1 ! Temp_sol 1.45mur verticale:Soil Temperature at Node ->Left axis variable-3 0,0 ! [unconnected] Left axis variable-4 0,0 ! [unconnected] Left axis variable-5 0,0 ! [unconnected] Left axis variable-6 *** INITIAL INPUT VALUES T sol 1.03 V T sol 1.45 h T sol 1.45 V T sol 0
SCHED_OCCUPATION SCHED_INCCO_MATIN
LABELS 3 "Temperatures [deg C]" "Temperatures [deg C]" "T sol" Instead of “
T sol 1.03 V”
you can write “T_sol_ 1.03_V” Marion Von: TRNSYS-users [mailto:trnsys-users-bounces@lists.onebuilding.org]
Im Auftrag von Gérôme Babic Bonjour, J'utilise Trnsys depuis peu et je suis en train de simuler la surchauffe dans une maison.J'ai seulement fait une pièce et je suis en train de regarder à la régulation mais après
eu des erreurs de convergence j'ai une erreur plus importante dans mon programme mais je comprend pas ce qu'il faut faire car en modifiant parfois certaines valeurs elle part puis elle revient. Je préfère tout changer au début que tout à la fin.Pouvez-vous
me conseiller ?Car même en supprimant le paramètre concerner, il me met que j'ai la même erreur Hi, I use Trnsys lately and I am simulating superheating in a home. I only made a room and I am looking
inregulation but after had of errors of convergence I have a more important error in my programme but
i don't know what to do because sometimes by changing some values
the programme running. I prefer changing everything at the beginning wheneverything at the end. Can you help me? Because even by abolishing parametre to
concern, he puts me that I have the same error
The TRNSYS processor has reported that an unrecognized control card was found trying to read the input file.This error can be caused by underspecifying a required number of items
in the input file. For example, specifying only 9 parameters after a "PARAMETERS 10" card has been read can this error. The line that caused this error is listed in the reported information below Reported information : SCHED_INCCO_MATIN |