[TRNSYS-users] The Calling Order Specification Statement (LOOP)

[Bellini Alessandro <Alessandro.Bellini@eurac.edu>]

Dear Trnsys users,

 

I would like to use the LOOP-REPEAT statement in order to help TRNSYS to manage better the components order during the simulation (defining internal loops) reducing possible convergence problems.

I try to use this function (following the manual) but when I run the .dck file the simulation stopped sending this message on the screen: “Range check error” .

Has anyone ever used the LOOP-REPEAT statement?

 

 

Thanks for the support

 

Regards

 

Alessandro Bellini

Institute for Renewable Energy

 

EURAC research

Institute for Renewable Energy
Via Luis-Zuegg 11, I-39100 Bolzano

t +39 0471 055 647

f +39 0471 055 699

alessandro.bellini@eurac.edu

www.eurac.edu

 

EURAC research

Legal Seat

Viale Druso 1, I-39100 Bolzano

This transmission is intended only for the use of the addressee and may contain confidential or legally privileged information.
If you receive this transmission by error, please notify the author immediately by mail and delete all copies of this transmission and any attachments.
Any use or dissemination of this communication is strictly prohibited by the "Privacy-Code", D.Lgs. 196/2003 and may lead to penal prosecution and liability for damages.

 

P Think before you print