Re: [TRNSYS-users] TRNSYS17 and GENOPT

[David BRADLEY <d.bradley@tess-inc.com>]

Carlo,
  TRNOPT creates a template of the TRNSYS input file replacing certain parts of the input file with special characters. When GenOpt chooses a new set of values to try, TRNOPT replaces those special characters with the new values. This is a bit of an oversimplification of course.
 
  The error that you are getting is a bit odd; the VERSION keyword occurs right at the very beginning of the TRNSYS input file and indicates which version of TRNSYS the dck was intended for. If you have a variable named "version" in your input file that might cause the problem since there might be confusion between the variable name and the keyword.
Best,
 David

On 11/26/2013 02:22, Carlo Filippo Bonacina wrote:

Dear all,

is it possible to use Trnsys17 with Genopt?

During the simulation this fatal error appears: 

"Fatal Error at time   :         0.000000

    Generated by Unit     : Not applicable or not available

    Generated by Type     : Not applicable or not available

    TRNSYS Message     48 : The TRNSYS processor has reported that an unrecognized control card was found while trying to read the input file.  This error can be caused by underspecifying a required number of items in the input file.  For example, specifiying only 9 parameters after a "PARAMETERS 10" card has been read can cause this error. The line that caused this error is listed in the reported information below.

    Reported information  : VERSION"

Why?

Otherwise is there an other software for parametric simulations?

How does TRNOPT work?

Thanks a lot.

_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@cae.wisc.edu
https://mailman.cae.wisc.edu/listinfo/trnsys-users

-- 
***************************
David BRADLEY
Principal
Thermal Energy Systems Specialists, LLC
22 North Carroll Street - suite 370
Madison, WI  53703 USA

P:+1.608.274.2577
F:+1.608.278.1475
d.bradley@tess-inc.com

http://www.tess-inc.com
http://www.trnsys.com