Dear all,
I would also like to simulate the drain-back of a flat plate collector but I do not know how to do it. So far, I simulated the FPC using the type 1b but now I do not know how can I simulate the drain-back, because
if the inlet flow rate of the collector is zero kg/h also the outlet flow rate will be zero. I think that I should change the type 1 for another one, but I do not know which is the type that I should use, could you give me a clue, please?
Thank you in advance,
Carol Pascual
Energía Térmica/Thermal Energy
División de Energía y Medio Ambiente/
Energy and Environment Division
TECNALIA
Área Anardi,5
Laida Bidea, Edificio 204
E-20730 Azpeitia - Gipuzkoa (Spain)
T 902 760 000*
M 667119581
T +34 946 430 850 (International calls)
Este mensaje puede contener información confidencial o privilegiada. Si no eres el destinatario de este mensaje, notifícaselo
por favor al remitente y bórralo sin reenviarlo o guardarlo dado que está legalmente prohibido.
Mezu honek daukan informazioa isilpekoa edo pribilegiatua izan daiteke. Zuri zuzendua ez badago emaiozu, mesedez, horren
berri igorleari eta ezaba ezazu bidali edo gorde gabe, legalki debekatua dago eta.
This message may contain confidential, proprietary or legally privileged information. If you are not the intended recipient
of this message, please notify it to the sender and delete without resending or backing it, as it is legally prohibited.
Por favor, piensa en el medio ambiente antes de imprimir este e-mail.
Mesedez pentsatu ingurugiroan e-mail hau imprimatu baino lehen.
Please, consider the environment before printing this e-mail.